What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 18.06.2025 06:55

Barnstars:
This is where the MOV conducts again, and dissipated the energy.
(Dc diagram shown, AC is similar).
A circuit breaker is similar, but is resettable.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
What’s a historical event you wish more people talked about?
The third is lightning and “how it gets conducted into a home.”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
a photo is worth a thousand words.
Can shaving hair by Veet in our vagina cause diseases?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
What does a fuse do?
What's the most sordid activity you've ever seen or heard about at a bachelorette party?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
A fuse is a non-resetable over current circuit protector.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Insulin Isn't Just Made by The Pancreas. Here's Another Location Few Know About. - ScienceAlert
The bolt then partially travels down the line to your home.
eight
One is “what exactly is in a ‘surge protector’ ? ”
Here is a simplified AC power diagram.
These devices are installed between the “hot” and “neutral” and protective ground.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
An AC voltage/ current source, and an ac inductive load.
Upvotes:
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–10[John johnson John Johnson ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
These are simplified answers to the original question, and does not change anything I wrote above.
Too often, Black patients get late diagnoses of deadly skin cancer - The Washington Post
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
so, what happens?
I post the exact comment here.
What is your favourite summer outfit? Why?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The MOV will conduct when the voltage exceeds 50% of line voltage.
For this case there are devices called Metal oxide varistors (MOV).
What is the estimated number of people with an extra X chromosome?
what exactly is a ‘surge’ protector?
What is lightning?
He then describes Rainy Season and Lightning.
There are three different concepts here that are getting confused.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
It also is a device that limits the change in current flow.
This device then solves the entire problem.
but I think this circuit , shows a few more pieces.
2024–10–16 [ OO OLAOYE OYEBODE ]
Because the load is inductive, the current lags the voltage.(by a bit).
[image of Common-mode choke]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
First Sentence:
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
In schematic diagrams this is the symbol for a fuse:
At one ohm, the resistor has a maximum of 1 watt power.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
One
But it can get overloaded, and no longer works.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is where this question deviates from being a 'generic' question, and becomes more specific.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is 'the assistant's answer'
At least they know the answer if they wanted it.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Now when you have a certain ac resistance, then a current flows in a loop.
He then describes the function of a fuse.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–14 [Omar Gharbi Omar Gharbi ]
but this device (an Inductor) … impedes the rapid changes in the current.
the problem then depends on "how fast does the fuse operate?".
He then asserts :
nine
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
There are two important concepts here.
[old diagram got deleted by accident]
The other is “what does a “fuse” do?”
So, the voltage could go up to 500 volts, and the fuse will not open up.
It seems Mohan does not understand the difference between a comment and an Answer.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Edit 2024–10.
This one hit behind the barn.